DIY-Wedding car decoration

Want to know how to Decorating wedding car with ribbon?
What you'll need:
silk ribbon
Wedding flower
 Scissors
Instructions:
Unravel the ribbon if it is spun on a spool. Straighten the ribbon so it lays flat. You may need to set books on the ribbon overnight to flatten it.
You should open all the windows of the wedding car and then pass the ribbon through either side and out toward the front of the car. 
Pull the ribbon across the front hood. Thread both ends of the ribbon through the front hood ornament or car mascot, if applicable. If your car does not have a hood ornament, just pull the ribbon across the front hood to the front bumper.
Tie a bow in the same way that you would tie a pair of shoe laces. Keep the ribbon snug as you pull both sides into a bow. Make sure the ribbon does not cover the front license plate. It will rest on the front bumper.
Secure the ribbon running across the hood of the car and the bow resting on the bumper using adhesive pads from a car wedding ribbon kit. These adhesive pads are specially designed to temporarily bond to the hood of your car without causing damage.
Reach under the ribbon and set each pad in place. Sweep your hand over the ribbon and gently press down to fasten the ribbon to the pad. Continue along the hood and down the front bumper; add enough pads to secure the bow.
♥♥♥